Pattern Lazer Cut

Here is my final pattern rendition that I cut on the lazer cutter from plywood. I only cut one of the circles rather than the original nine, because at the 4x4" scale, some details would be too small to see at a glance.  The wood looks good, but a bit burnt around the edges because I had to readjust the settings multiple times as the lazer didn't cut through all the way. I had to re-cut the edge 4 times and it almost set on fire.

I think the design might have looked better if I put higher contrast between the inside colours.

I think I'm going to use this as a cup coaster.

Lazer cutting the inside (3x speed)